Omron BP7100 Instruction Manual

The Omron BP7100 is an automatic upper arm blood pressure monitor designed for home use. It features IntelliSense technology for accurate and comfortable readings, a large LCD display with backlight, hypertension detection indicator, body movement detection, irregular heartbeat detection, memory storage for up to 100 readings with date and time stamps, and a wide-range D-ring cuff (22-42 cm). Below are key sections for safety, features, setup, operation, maintenance, and troubleshooting.

Features at a Glance

Key components: Main unit with LCD display, Wide-range D-ring cuff, AC adapter, Instruction manual, Storage case.

Safety Information

Read all instructions before use. For accurate measurements and safe operation.

1. Do not use on infants, young children, or persons unable to express themselves.
2. Do not use during periods of physical unrest or immediately after exercise.
3. Consult your physician before use if you have arrhythmia, blood circulation problems, or other conditions.
4. Do not use the monitor on an injured or sore arm.
5. Do not modify or disassemble the device.

WARNING! This device is not a substitute for professional medical diagnosis. Consult your physician for interpretation of readings.

Package Contents

Unpack and verify all components are present.

• Omron BP7100 Blood Pressure Monitor (Main Unit)
• Wide-range D-Ring Cuff (22-42 cm)
• AC Adapter
• Instruction Manual
• Storage Case
• Quick Start Guide

NOTE: 4 AA batteries are not included. For battery operation, insert 4 AA alkaline batteries.

Device Overview

Front Panel: START/STOP button, Memory button, Power button, LCD display.

LCD Display Icons: Systolic pressure, Diastolic pressure, Pulse rate, Hypertension indicator, Irregular heartbeat symbol, Body movement symbol, Memory indicator, Battery level, Date/Time, Average reading.

Connections: AC adapter jack (rear), Cuff connector (left side).

Initial Setup

Before first use: Set date/time, install batteries or connect AC adapter.

1. Insert batteries: Open battery compartment, insert 4 AA batteries observing polarity.
2. Set date and time: Press and hold Memory button for 3 seconds. Use START/STOP to adjust values.
3. Connect cuff: Plug cuff tube into connector on left side of unit until it clicks.
4. Apply cuff correctly: Wrap cuff on bare upper arm 1-2 cm above elbow.

CAUTION! Ensure cuff is not twisted and artery mark aligns with brachial artery.

Taking a Measurement

For most accurate results, measure at the same time each day.

1. Sit comfortably with feet flat on floor and back supported.
2. Rest for 5 minutes before measuring.
3. Apply cuff to left upper arm (or as directed by physician).
4. Position arm so cuff is at heart level on table.
5. Press START/STOP button. Unit will inflate automatically.
6. Remain still and quiet during measurement.
7. Reading displays when measurement is complete. Cuff deflates automatically.
8. Record reading if desired. Unit stores automatically in memory.

Tip: Avoid eating, smoking, or exercising for 30 minutes before measurement.

Understanding Results

Normal blood pressure: Below 120/80 mmHg. Hypertension stages indicated per guidelines.

NOTE: Single readings may vary. Track trends over time for accurate assessment.

Memory Function

Stores up to 100 readings with date and time stamps.

1. View memory: Press Memory button to cycle through stored readings.
2. Average reading: Displays average of last 3 readings taken within 10 minutes.
3. Clear memory: Press and hold Memory button for 5 seconds while in memory mode.
4. Memory full: Oldest reading is overwritten when memory exceeds 100 readings.

WARNING! Clearing memory is permanent. Consider recording readings elsewhere before clearing.

Care & Maintenance

Unplug AC adapter or remove batteries before cleaning.

1. Clean monitor with soft, dry cloth. Do not use solvents or abrasives.
2. Clean cuff with mild soap and damp cloth. Air dry completely before storage.
3. Store in provided case in cool, dry place away from direct sunlight.
4. Replace batteries when low battery indicator appears.
5. Do not expose to extreme temperatures, humidity, or strong magnetic fields.

CAUTION! Never immerse monitor in water or other liquids.

Specifications

• Measurement Method: Oscillometric
• Pressure Range: 0-299 mmHg
• Pulse Rate Range: 40-180 beats per minute
• Accuracy: Pressure: ±3 mmHg, Pulse: ±5% of reading
• Memory: 100 readings with date/time
• Cuff Size: 22-42 cm (arm circumference)
• Power Source: 4 AA batteries or AC adapter (included)
• Battery Life: Approximately 300 measurements
• Dimensions: 123mm (W) × 85mm (H) × 141mm (D)
• Weight: Approximately 340g (without batteries)
• Operating Conditions: 10°C to 40°C, 30% to 85% RH

Troubleshooting

Reset: Remove batteries and AC adapter for 1 minute to reset device.

Service: For service, contact Omron Healthcare at 1-800-634-4350 or visit www.omronhealthcare.com