Omron Blood Pressure Monitor Manual BP7100

The Omron BP7100 is an automatic upper arm blood pressure monitor with IntelliSense technology for accurate readings, a wide-range D-Ring cuff (22-42 cm), a large backlit display, hypertension indicator, irregular heartbeat detection, memory storage for up to 100 readings, date/time stamp, and averaging of last 3 readings. It is clinically validated and designed for home use. Below are key sections for safety, features, setup, operation, maintenance, and troubleshooting.

Features at a Glance

Key components: Main unit with display, D-Ring Cuff, AC Adapter, Instruction Manual, Storage Case.

Safety Precautions

Read all instructions before use. For personal home use only.

1. Do not use on infants, children, or persons who cannot express themselves.
2. Do not use during or immediately after physical exercise or bathing.
3. Do not use on an arm with an intravenous drip or surgical wound.
4. Consult your physician for interpretation of readings and diagnosis.
5. Do not disassemble or modify the unit.

WARNING! This device is not a toy. Keep away from children. Do not use if the cuff is damaged.

Parts Identification

Familiarize yourself with the main components.

1. Main Unit: Contains display, START/STOP button, MEMORY button.
2. Display: Shows systolic/diastolic pressure, pulse, icons.
3. D-Ring Cuff: Arm cuff with metal ring and air tube connector.
4. Air Tube: Connects cuff to main unit.
5. AC Adapter Jack: For optional AC power.
6. Battery Compartment: Holds 4 AA batteries.

CAUTION! Ensure the air tube is securely connected before use.

Initial Setup

Prepare the monitor for first use.

1. Insert Batteries: Open battery compartment, insert 4 AA batteries observing polarity.
2. Set Date and Time: Press the MEMORY button for 3 seconds, use START/STOP to adjust.
3. Apply the Cuff: Place cuff on bare upper arm. The tube should run down the center of your arm.
4. Positioning: Sit quietly for 5 minutes before measuring. Keep feet flat, back supported, arm at heart level.

Tip: For most accurate results, take measurements at the same time each day.

Taking a Measurement

Follow these steps for a proper reading.

1. Remain still and quiet. Do not talk during measurement.
2. Press the START/STOP button. The cuff will inflate automatically.
3. Remain still with your arm relaxed until deflation is complete.
4. Your systolic, diastolic pressure, and pulse rate will display.
5. The reading is automatically stored in memory.
6. To turn the unit off, press START/STOP again, or it will power off automatically.

WARNING! Do not inflate the cuff when it is not wrapped around your arm.

Understanding the Display

Icons and symbols on the screen.

Main Readings: Systolic Pressure (top number), Diastolic Pressure (middle number), Pulse Rate (bottom number).

Icons:
Hypertension Indicator ( ) - Appears if systolic ≥ 135 or diastolic ≥ 85 mmHg.
Irregular Heartbeat Symbol ( ) - Appears if an irregular rhythm is detected.
Memory Icon (M) - Indicates memory recall mode.
Average Icon (AVG) - Displayed when showing the average of last 3 readings.
Date & Time - Shows when the reading was taken.
Battery Icon - Indicates battery level.

Memory Function

Stores and recalls up to 100 readings.

1. To view stored readings: Press the MEMORY button. The most recent reading appears.
2. Press MEMORY again to scroll through previous readings (display shows memory number and date/time).
3. To clear all memory: Hold down the MEMORY button for more than 3 seconds until "CLr" appears.
4. Average Function: After taking 3 readings, the average will be calculated and can be viewed.

Note: Memory is retained even when batteries are removed.

Care & Maintenance

Unplug AC adapter and remove batteries before cleaning.

1. Clean cuff with a soft, dry cloth. Do not wash or immerse in water.
2. Clean main unit with a slightly damp cloth. Do not use alcohol or abrasive cleaners.
3. Store in the provided case in a cool, dry place away from direct sunlight.
4. Replace batteries when the low battery icon appears.
5. Do not bend or twist the air tube excessively.

CAUTION! Do not use the monitor in humid places such as a bathroom.

Specifications

• Measurement Method: Oscillometric (automatic inflation/deflation).
• Pressure Range: 0 - 299 mmHg.
• Pulse Range: 40 - 180 beats per minute.
• Accuracy: Pressure: ±3 mmHg, Pulse: ±5% of reading.
• Cuff Size: 22 - 42 cm (arm circumference).
• Memory: 100 readings with date and time stamp.
• Power Supply: 4 x 1.5V AA batteries or DC 6V AC adapter.
• Auto Shut-off: Approx. 1 minute after measurement.
• Operating Conditions: 10°C - 40°C, 15% - 90% RH.
• Dimensions (Main Unit): Approx. 128mm (W) x 105mm (H) x 141mm (D).

Troubleshooting

Reset: Remove batteries for 1 minute to reset the unit.

Warranty & Support

Omron Healthcare, Inc. warrants this device to be free from defects in materials and workmanship for a period of Five (5) Years from the date of purchase. This warranty does not cover damage from misuse, accident, or unauthorized repair. For service under warranty, contact Omron Customer Support.

Customer Support:
Website: www.omronhealthcare.com
Phone: 1-800-634-4350
Address: Omron Healthcare, Inc., 1200 Lakeside Drive, Bannockburn, IL 60015 USA

Dispose of the device and batteries according to local regulations. Do not dispose of with household waste.